Choose market region


Integrated grab

GR20R2 integrated grabber was developed especially for the tough environments grabbbers are exposed to in railroad work where they are often used for dragging heavy rails and railroad ties.


  • Robust construction designed for demanding, heavy-duty use e.g., in railroad work.
  • Angled down up to 42 degrees
  • Wide grasp – 32.3 inches
  • Protected cylinders

* Standard attachment combinations: S45, S50, S60 and SMP2
  Not possible: S1 and S2
  Other attachment combinations on request. 

  • Largest grip width A: 32.30 inches
  • Width B: 15 inches
  • Length C: depending on coupler inches
  • Weight: 308 lbs
  • Clamping force at 21 Mpa: 3,850 lbs
  • Angled at 35–42° depending on the bracket:
  • Detachable:
  • Protected cylinders:

System engcon

What is most important for you?

  • Profitability

    System engcon, centred around the tiltrotator, saves both time and fuel.

  • Safety

    Fewer machine transits and less need for manual work mean increased safety at the workplace.

  • Flexibility

    The tiltrotator's ability to tilt and rotate makes the machine a good all-rounder that carries out most tasks with greater precision.

  • Efficiency

    Fewer machine movements and faster jobs mean less wear on the machine.

Read more about concept engcon

404 - page not found

We couldn't find the page you're looking for.

An error has occurred

Try reloading the page again to see if the error recurs.

An error has occurred

We could not connect you to the internet; make sure you are connected to the network.