Compatible with your
The new GR20R2 integrated gripper is specially developed for the tough environments that grippers are exposed to on the railway, where a gripper will often be used to pull and lift heavy rails with excavators.
• Robust construction designed for heavy and difficult usage, such as in the railway industry.
• Angled down up to 42 degrees
• Large grab width – 820 mm
• Protected cylinders
* Standard hitch combinations: S45 and S60.
Other hitch combinations may be available – please ask.
What is most important for you?
System engcon, centred around the tiltrotator, saves both time and fuel.
Fewer machine transits and less need for manual work increases safety at the workplace.
The tiltrotator's ability to tilt and rotate makes the machine a good all-rounder that carries out most tasks with greater precision.
Fewer machine movements and faster jobs mean less wear on the machine.
Despite the increasing popularity of tiltrotators, many excavator manufacturers do not yet sell 'tiltrotator-ready' machines on certain markets. There are two main considerations when buying a new excavator for use with a tiltrotator - dipper length and hydraulics. Ideally, a shorter dipper should be chosen to take into account the build height of the tiltrotator. For example, if the standard dipper length is 2500mm, choose one 2000mm long so that the extra reach resulting from the addition of the tiltrotator still falls within the manufacturer's safe working range and that there is no chance of the bucket or other attachment hitting the cab when fully crowded.
The standard machine hydraulics can often be used for tiltrotator operation, but the machine controls may not be sufficiently sophisticated to fully exploit the capabilities of the attachment. Tiltrotators are usually supplied with so-called fully proportional control systems. These allow the hydraulic power to be gradually increased according to the needs of the attachment and the task to be completed, for example when pouring type 1 or concrete into a narrow area or using grabs or pallet forks. Non-proportional, or on/off systems which are generally button-operated do not allow the delicacy of control necessary for many tiltrotator operations.
If the excavator has two dual-acting proportionally controlled hydraulic circuits, then basic tiltrotator operation should be possible using the excavator's controls. A third, non-proportional circuit will be required for the tiltrotator hitch. Where a single, dual acting circuit is fitted, it is often more cost-effective to use engcon's DC2 control system which manages the hydraulic switching and flow proportionally within the tiltrotator, rather than have additional circuits fitted.
The pin geometry on your existing buckets is unlikely to be compatible with the S-type coupler fitted to standard tiltrotators. Choosing a Unisafe/PUP coupler to allow you to use your existing buckets is likely to be a false economy for the simple reason that tiltrotator (s-type) buckets are designed for tiltrotator digging. Not only is the angle of the bucket optimised for tiltrotator use, but the bucket geometry (shape, size, etc.) is specific for rotational and angled digging and grading. The saving you make by choosing the S-type coupler can be re-invested in top bracket adapters to convert your existing buckets and other attachments.
If you are running hydraulic tools, you can also purchase adapter brackets EC-Oil ready, or pre-fitted with EC-Oil and thus convert your current hydraulic tools with ease for the S-type coupler.
404 - Page not found
We couldn't find the page you're looking for.
An error has occurred
Try downloading the page again to see if the error recurs.
An error has occurred
We could not connect you to the Internet